Zenith HDR230 Manual de servicio descargar pdf (Pagina 14)

3-3

2. SYSTEM S/W UP-DATE & DIAGNOSTIC S/W

• System S/W Up-date

1) Connect the serial cable between the connector for a service and the serial port of PC, and run TeraTerm

Program on the PC.

2) Switch to System Code Up-data mode by press select key and left Volume(

) key together at the front.

3) TeraTerm screen

- “Preparation for S/W Up-data is completed” message is displayed on the screen.

- Select ‘Send file’ from File menu of TeraTerm and select the file for Up-data.

At this time, select ‘binary’ from Option.

- The extension of this file is .phc.

4) Decompress this file at the system after this file is transmitted, and write it into the flash memory.

5) S/W is restarted after writing is done.

6) Check “S/W version” of “Troubleshooting” item from the setup menu whether the system code Up-date is

done.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 93 94

Sin comentarios

Zenith HDR230 Manual de servicio Pagina 14